- The instructions and warnings of the lifting beams
1. Do check wheather there is open weld of the appearance of whole lifting tool, and parts deformations, cracks etc.
2. Make sure that the lifting loads no more that WLL, in the process of being lifted, the beam should be in balance.
2. Make sure that the lifting loads no more that WLL, in the process of being lifted, the beam should be in balance.
3. Do not change the structure randomly, increase or reduce the parts of the beam.
4. When loading, strictly prohibited person under the beam.
4. When loading, strictly prohibited person under the beam.
5. When lifting, prevents the load migration or the rotation.
6. In the process of lifting and carrying,works should be continuous, balanced, no strikes, when the lifting tools is cracked, you should inspect wheathe the lifting parts deformed, weld open or not, if yes, stop using at once. If the lacquer is fell off, check wheath relavated with the deformation or not.
7. If the parts broken, replace the new one.
8. The person who operates the beam should be well trained.
9. The important seam welding should do the inspection every 6 months.
10. The lifting tools should be checked termly, the director should check once less than three months, dealing with them upon the actual situation.
11. The lifting beam should be cleared and placed on an even and hard floor, kept in the place of airiness, dry and clear, kept away by special person.
12. The transport parts should be lubricated termly prevent the look situation.
13. It is prohibited in the high- temperature area.
6. In the process of lifting and carrying,works should be continuous, balanced, no strikes, when the lifting tools is cracked, you should inspect wheathe the lifting parts deformed, weld open or not, if yes, stop using at once. If the lacquer is fell off, check wheath relavated with the deformation or not.
7. If the parts broken, replace the new one.
8. The person who operates the beam should be well trained.
9. The important seam welding should do the inspection every 6 months.
10. The lifting tools should be checked termly, the director should check once less than three months, dealing with them upon the actual situation.
11. The lifting beam should be cleared and placed on an even and hard floor, kept in the place of airiness, dry and clear, kept away by special person.
12. The transport parts should be lubricated termly prevent the look situation.
13. It is prohibited in the high- temperature area.
If the lifting beam happens to any one situation as below, it should be replaced.
1. If the beam body and lifting ear have obviously deformation and cracks.
2. The lifting beam has open seam welding due to long term use. Can not be repaired.
3. The lifting or its parts rust seriously and can not use safely.
4. The pin abrasion to 15% of the norm dimension, it should be replaced.
5. If it has the crack after inspection, it should be replaced.
6. The surface of the beam have seriously damage .
7. The main parts of the lifting beam have serios deformation.
8. If the lifting beam tested can not be up to the lifting capacity of 80%.
1. If the beam body and lifting ear have obviously deformation and cracks.
2. The lifting beam has open seam welding due to long term use. Can not be repaired.
3. The lifting or its parts rust seriously and can not use safely.
4. The pin abrasion to 15% of the norm dimension, it should be replaced.
5. If it has the crack after inspection, it should be replaced.
6. The surface of the beam have seriously damage .
7. The main parts of the lifting beam have serios deformation.
8. If the lifting beam tested can not be up to the lifting capacity of 80%.
