1. Metallurgical Clamps (clamps) to hold the objects’ hanged on the clamp through openong and closing the mechanical lever under theoutside force. its is characteristics are simple structuri, flexible action, lifting reliable.
  2. Working principle (Mechanically)
The lifting crane hang over the link of th clamp, when the clamp lift, tapered ned of start and stop setup in the start and stop seat, verticality, taped ned hang over starting and stopping seat, clamp go up home position of the top of bilet then go down, when the
suporting plate come into contact with billet, travelling crane’s lifting hook go down, connecting rod, beam also go down, tapered ned connect to motherboard of start and close seat, because of tapered ned respect oneself, 90 degree in start and close seat,
hook of travelling crane going up,pincers teeth clamp bullet. Through go up and horizontal move, arrive to the top of point.
Hook of travelling crane go down, the lift goods come contact other object (or floor), then it can not go down, at that time jaw open billet loosen. Travelling crane continu go down, angular separation of connect rod become bigger tapered ned also go down to start
come  connect to the bottom of it, verticality. Lifting hook of chain block go up, hanger lift, horizontal move to original point, then fhinish the circle.
  3. The design of clam and test Standards is working load and applicability range. Strictly no overweight.
  4. Clamps avoid lash and crash, or it should be check all the parts of clamp, and after the confirmetion from safety test deparment, there is not satety problem, then it can continu to use.

5. Do not cancel or add any parts, or cutting and jointing on theclamp.
6. When the clamp, strictly no person below the clamp.

7. Inclined to lift the object is the main reason for damageand there are safety issues. During use, should we keep object suspended in normal position (horizontal), and not inclined.
8. If you need repair, they will f made only after the clip was placed on a flat surface.
9. After use, be placed on a flat surface or a console.

The correct and reasonable usage of the type C clamps will assure of the safe operation and extend its life. Please pay attention the followings:

1. Use the C type clamp, first learn the saftey operation specification.
2. No overload. Make sure balance loading when lifting.
3. Befor the use, check the whole surface of clamp if there is jointing open, parts distortion, crakt and so on.
4. Do not change the construction, add or reduce the parts.
5. Control the lift speed, prevent moving or swivel during lifting.
6. Clamp should keep the load through the lift ear, the meatus should be a little higher, avocd the lift coil come out.
7. When lift the steel coil or aluminium coil, the intine should be connected with the flank of lift coil, lifting point should remove 30-80mm to the intine of steel coil, the tine an not overload.

8. Traveling crane should keep continue, balance, avoid the lift coil faldown, and avoid the shock of clamp.
9. Keep the environment dry, no corrosion, if the print fall down it should be printed again.
10. Before the use, check the parts if there is defect.
11. Use the C type clamps, it must be handled by the special operator, he should learn all safety operation specification, use the correct method.

Safety inspection of metalurgic clamp

1. Please check the clamp before use, if the clamp has the crack, jointing open, please tell the safe department to check.
2. Monthly inspection.
Safety director on spot should check  in record test per month, make sure all the parts according to sefty standard, and make a note.
3. Yearly inspection
Please check the condition.

If the metallurgy clamp has one of these problems, please replece parts or reject:

1. Any parts of the clamp have a crack.
2. Some parts break, is should be changed or rejected.
3. The main parts are open or distortion.